posted 19 July 2013 06:14            

---

Maybe I missed something, but I have some hot values that are assigned a grid value of 1 (incremental pitch, index and like that). In Kyma Control's VCS, these parameters are all set to "0" (though the parameter values in the preset are not) and these knobs/sliders don't actually move at all. Did I screw something up? Forgive my ignorance if this has been asked and answered... the search function revealed nothing about it.

IP: Logged

posted 19 July 2013 06:47            

---

Oh, and I should say that these knobs/sliders are behave as they should in the actual VCS, just not in the Kyma Control version.

IP: Logged

posted 19 July 2013 10:58            

---

Is there a red exclamation point over the Configure tab in the lower right corner?

IP: Logged

posted 19 July 2013 11:30            

---

No, there's no exclamation point and most of the controls operate fine. In fact, the faders that are set increments work and if I change the potentiometer into a fader, it'll work. The potentiometers with a grid of "0" all work fine, it's only the ones set to increments that don't work. Oddly enough, this morning, the numbers for the knobs in question show the proper values - last night they all showed "0".

IP: Logged

posted 19 July 2013 13:35            

---

Please send us the Sound by email so we can try to see what's going on. Thanks!

IP: Logged

posted 19 July 2013 14:39            

---

Hmm. I changed all of my incremental potentiometers for faders so that I could use it at the gig I may or may not be playing this weekend (faders are easier to play with Kyma Control anyway). However, I went down to the studio to change them back for potentiometers so I could send you the file and wouldn't you know it? They all worked. There have been odd anomalies with it this week - nothing showstopping or permanent, just that it's slow to update sometimes - so maybe there's something going on with my setup. I'm using the Delora thing to connect through my Mac rather than using a router.

In any event, it's working now, so unless it crops up again, I'll not worry too much about it. If it does, I'll change the faders back to knobs and send it over to you.

IP: Logged

posted 20 July 2013 09:03            

---

So far, this issue seems not to have returned. Looks like it was an anomaly. As I said, my VCS is very slow to update and quirky on Kyma Control, so maybe I should put it down to that.

IP: Logged

All times are CT (US)