|
 Kyma Forum
 Kyma Support
 Using motormix and sequencer to send MIDI CCs
|
| next newest topic | next oldest topic |
| Author | Topic: Using motormix and sequencer to send MIDI CCs |
|
mk23 Member |
posted 15 May 2011 16:19
 
Hi, I have been playing around with iPad Kyma Control and CapyLink but I am a bit stuck. It seems that once I set the Kyma preferences setting "External controller" to Motormix, I loose the ability to control the VCS using MIDI CCs sent from my sequencer (Cubase or Logic, always the same behaviour). I'm running Kyma 6.80 and tested 6.79 briefly. Is that supposed to happen? I can set the "External controller" preference back to Other, reset the DSP and then use MIDI CCs fine. But of course then Kyma Control isn't working! Is it really the case that I can control the VCS from either the Motormix or a sequencer, but not both at the same time? David IP: Logged |
|
ChristianSchloesser Member |
posted 15 May 2011 17:10
Hi, if you use an other MIDI Channel then 1 for you MIDI CCs it will work. Channel 1 is occupied by the Motormix if it is switched on in the preferences. This is my experience with a "hardware " motormix. All the best [This message has been edited by ChristianSchloesser (edited 15 May 2011).] IP: Logged |
|
mk23 Member |
posted 16 May 2011 14:54
Hi Chris, Thanks for the advice, I will try that next time I'm in front of Kyma. Cheers David IP: Logged |
All times are CT (US) | next newest topic | next oldest topic |
  |
|
Contact Us | Symbolic Sound Home
This forum is provided solely for the support and edification of the customers of Symbolic Sound Corporation.
Ultimate Bulletin Board 5.45c