|
 Kyma Forum
 Kyma Support
 FW HUBS
|
| next newest topic | next oldest topic |
| Author | Topic: FW HUBS |
|
tiego Member |
posted 23 July 2004 09:06
 
Hello The Kyma FW interface isnt recognised thru my FW HUB. Does this apply to all Hubs or is there one that you would recommend? thanks, Tieg IP: Logged |
|
SSC Administrator |
posted 23 July 2004 09:44
There should be no problem using the Flame through a hub. Is it a powered hub or is it bus powered? If your computer is not supplying FireWire power and the hub is bus powered, then the hub will not have any power to run. IP: Logged |
|
tiego Member |
posted 23 July 2004 19:23
that hub was powered. Then i tried to daisy chain:HD did get a signal from computer (starts up) but didn't show on FW bus or desktop. Then i reinitialised power on Flame. Showed up. wasn't that stupid? I am going to try out Kyma working from FW HD connected to flame. That may be stupid too... IP: Logged |
All times are CT (US) | next newest topic | next oldest topic |
  |
|
Contact Us | Symbolic Sound Home
This forum is provided solely for the support and edification of the customers of Symbolic Sound Corporation.
Ultimate Bulletin Board 5.45c